How to properly use and maintain the cell phone jammer?

With the increasing use of cell phones, it is increasingly difficult to prohibit the use of cell phones in some places where they are not allowed. In this case, some people often choose to use cell phone signal jammers, but many people do not know how to use cell phone signal jammers correctly. Today, I will talk about how to properly use and maintain the cell phone signal jammer.

Section. As we all know, cell phone signal jammer is a high-tech product. It will turn on the power switch when it is in use. In this case, before the switch is turned on, the antenna has been irradiated, which will easily cause damage to the machine itself. Therefore, it is necessary to pay attention to this point when using a cell phone signal jammer.

When turning on the cell phone jammer, do not press the button repeatedly within a second. This will only increase the failure rate of the device and may even lead to property damage. When you turn on the phone, you should turn it on and then turn it off in parts, not all at once.

Now that you know how to use the cell phone signal blocker, let's talk about how to maintain it. As mentioned above, when turning on the cell phone signal jammer, avoid pressing the button multiple times in a second. This will only increase the failure rate of the device and may even lead to property damage. When turning it on, it should be done in stages and then turned off in stages; it should not be turned on or off at once.

Also, pay attention to temperature control: exposing the phone jammer to direct sunlight for a long time or leaving it unattended in a hot area (such as the trunk of a car) will greatly reduce its life.

After powering on the cellular high power signal jammer, the user should first decide if they need to block GSM or CDMA signals. This ensures that interference can be generated in a certain direction, thus maximizing its performance.

If you want to use it to block both CDMA and GSM signals, you have no choice but to change bands as shown above (the device has two bands: one for blocking CDMA signals and the other for blocking GSM cellular networks).

The next step is to select the direction in which you want to block cellular signals. You can orient the antennas according to their location relative to you, or as far away from your location as possible so as not to disturb others in your area after using these devices.

When turning off or adjusting the power of the cell phone signal blocker, all signals must be turned off first, otherwise power surges and overheating may occur on the circuit board of the cell phone signal blocker, causing damage to the equipment.